Environmental Equipment, Inc. 
| IMR 200 This portable CO detector has been developed to detect CO leaks. The IMR 200 is very easy to use, simply turn the detector on and hold it near the area that you suspect a leak and if a trace of gas is found the red LED will illuminate and the audible alarm will sound. The treshold level can be configured at the factory. 
IMR-200
|
|
| HOW TO USE YOUR IMR 200 |
| 1. Turn the unit on, the buzzer will sound
and the green LED will illuminate. 2. The unit will buzz for a few seconds whilst calibrating. 3. Once the buzzer stops, the unit is ready. Move the sensor to the area to be tested. 4. If the unit detects gas the red LED will illuminate and the buzzer will sound. 5. If the unit detects static electricity the yellow LED will illuminate. |
| LOOKING AFTER YOUR IMR 200 |
| 1. As the unit is made of
several sensitive electrical components handle it carefully, do not blow
into the sensor or allow the unit to get wet. 2. If you are not going to use the unit for some time remove the batteries. |
| HOW TO DETECT
AND ABSORB STATIC ELECTRICITY |
| 1. Turn the unit on. 2. Bring the metallic edge on the back of the detector into contact with the area that you suspect of containing static electricity. 3. If static electricity is found the yellow LED will illuminate. |
| SPECIFICATION |
| Portable Gas-Detector IMR 200 Function: Detecting CO Power Consumption: 2 x 3.6V Lithium batteries Temperature: -10C ~ 50C Humidity: 95% RH or lower Duration of Use: About 8 hours continuously Weight: 30g Dimensions: 190mm x 20.3mm |
IMR Environmental Equipment, Inc. reserves the right
to adopt technical modifications without prior notice
IMR Environmental Equipment, Inc.
3634 Central Ave. - St. Petersburg,
FL 33711 USA
Phone: 727/328-2818 - Toll free:
1-800-746-4467
Fax: 727/328-2826
Email: Info@imrusa.com
©
Copyright 2003 IMR Environmental Equipment, Inc.